Strength vs. weight vs. work (rib geodetics)

While waiting (still) for my spruce to be shipped, I did some figuring…

Building from plans means not getting the wood factory cut and grooved.  There are just some pieces that you can’t buy off the shelf.  The Celebrity plans call for rib geodetic braces made of 3/32″ x 3/8″ Sitka spruce.  ACS and Wicks sell spruce capstrip down to 1/8″ thickness, but not 3/32″.  So the choices are to plane or sand down the entire length of the 1/8″ x 3/8″ strips, or use them as is and just sand the ends to fit the grooves in the top and bottom capstrips.  So how much extra weight will we end up with if we just use 1/8″ thick pieces?  It’s 1/32″ thicker, so we’ll do the math…

1/32″ x 3/8″ wide x 1464″ of capstrip = 17.25 in3 of extra spruce.  Sitka spruce weighs about 28 pounds per cubic foot (or 1728 cubic inches), so 17.25 / 1728 = .009928 ft3 x 28 lb gives us a little over a quarter of a pound, less whatever gets sanded off on the ends and scrap, etc.  So…  around four ounces or less; I can live with that.  Still, I’m thinking I may set up a spindle sander with a 3/32 gap to do the ends.  If it works well enough I could run the entire lengths of the strips through it, then so much the better.  Of course that would probably mean having to buy a new power tool.  Oh, no!  🙂