For a while I’ve been pondering how to set up the new wings on my bench. He’s got a pair of 10′ long steel rails, made from square tubing with slotted brackets to bolt them to his bench. He had put those together to support a router sled for flattening slabs of wood. Early on I figured out that we could attach them to the bench to properly orient the wing ribs for attaching the trailing edge and spars. The trailing edge stock needs to be glued on so that the taper exactly matches the angle of the aft end of the wing ribs, and the easiest way to do that is to have a flat surface that aligns the bottom of the TE stock witht he bottom cap of the ribs.
The plans call for attaching a 2×4 on edge to the edge of the work table with a shim under one side. This tilts the top edge of the 2×4 to the correct angle, which I measured at bout 14 degrees, to establish the right pitch to align the trailing edge and ribs. I was concerned about finding a perfectly straight, flat 10′ long 2×4, as well as shimming it consistently. All in all, I was nervous about how to set up the new wings on this bench.
A few days ago, I grabbed one of the ribs I have here along with a short cut-off piece of trailing edge stock. I started exploring different ways I could jig up a wing on the bench, and came to a surprising (and happy) discovery. With the TE stock flat on the front edge of the bench and the rib inserted into the notch, a standard 2×4 on the opposite side of the bench will perfectly support the rib right under the main spar location. So, I could clamp the trailing edge down on some release tape or waxed paper (to keep the epoxy from sticking to the bench), support the other end with a 2×4 – or multiple shorter pieces of 2×4 – and assemble the wing that way. Sweet! I’ll test that configuration when I bring the lower left wing home, which is built but not varnished yet. I’ll need to apply the varnish before taking it to the hangar for storage, and I can check to make sure my jigging idea will work as well as I think it will.