Well, the work bench is cleared off — well, at least enough to get both jigs on it. I’ve got a couple dozen sticks of geodetic brace stock shaved down. The epoxy syringes are filled. All I need now is a razor saw and a steam setup.
Yes, I have a razor saw. Somewhere. I pulled it out during the kitchen remodel, and I remember seeing it in a box of tools we were using, but now I can’t find it. It’s a Zona, good quality but inexpensive. A new one is on the way. Two, in fact; one medium and one fine tooth. I also have a steam box that I built for the capstrips, but I’m unsure whether I’ll use it in the basement. It takes bench space (which I now don’t have down there), and drips water out the end by design. I’m thinking about ways I can use it vertically. I had looked at rigging up a piece of pipe or something with a heating element for hot water, but it looked like an awful lot of extra work considering I’m over halfway through the ribs. I’ll probably need it for the tail and wingtip bows as well, but I’m not entirely sure yet how I’m going to steam 6 to 9 foot long strips of wood. Tonight I tried soaking half a dozen capstrips in a bucket of hot water for an hour — we’ll see how well that worked.