Flying wires vs. lift struts

I emailed Dave at Fisher Flying Products asking about the lift struts I have seen used on several Celebrities that I’ve seen in pictures.  I still have not seen an actual Celebrity “in person”, nor any other completed Fisher design for that matter – just a partially built single seat ultralight at Oshkosh.  It seems you have a choice between lift struts or flying wires.  Personally, I like the look of flying wires a lot better.  It just has that classic wire-braced biplane look.  I know that a cylinder shape, such as a wire, has much higher drag than streamlined tubing.  A cylindrical object will have 10 times the drag of a streamlined shape of the same frontal area.  The wires, however, will be much thinner than struts, 5/32″ — meaning that they would produce drag roughly equivalent to 1-9/16″ wide streamlined struts.  BUT…  the plans call for 1-1/8″ and 1-1/4″ round tubing for the lift struts.  The flying wires would have far less drag than those.  I could probably replace the round aluminum tubing with smaller streamlined steel and pick up some drag reduction there, but the fact remains — I just don’t like the look of the lift struts.

It’s not like this airplane will be a speed demon no matter what I do, so I’m not really worried about what may be a small drag penalty for the wires.  If I wanted to fly faster and more efficiently without regard for anything else, well, I have an RV-12 for that (acknowledging that “faster” is entirely relative here).  It looks like I can have the wires made to my specs by Aircraft Spruce, swaged and tested with professional equipment so I don’t have to worry about getting it perfect on my first try.

More jig work and research

I did some additional work on the rib jig yesterday, including installing the main spar locating block and cleaning up a few nail points that were poking out the bottom.  I cut a bunch of blocks to locate the outer shape of the ribs, but did not install them yet.  I want to wait until I have some spruce stock to put in place, so I make sure it’s all in the right place.  I really want these to turn out as close to perfectly consistent as possible.  I had planned to use some pine cut down on the table saw to set up and test the jig, but it occurred to me that I had no way to know for sure my pine strips would be the exact same size as the capstrip stock supplied by Aircraft Spruce.  So, it’s time to order some wood.